PLACING OF REINFORCEMENT TOLERANCE ACCORDING TO IS CODES

PLACING OF REINFORCEMENT TOLERANCE ACCORDING TO IS CODES


Tolerance in the placing of reinforcement, is very necessary because no work was to be done fully 100 percent accurate. The strength of any structure can be achieved to construct and provide proper reinforcement in effective locations. If any type of error occurs, it may reduce the strength of the structure.

EXAMPLE: 

The taising of bottom bars over the top bars. The specified limits is 15 cm in slabs, if the limit exceed, it will reduce 20% of its load carrying capacity. 

The placement of cover reinforcement is another important. The tolerance in cover should be 

Depth 20 cm or less: +- 10 mm depth 
Depth greater than 20 cm : +- 15 mm depth 

Reinforcement bars placing tolerances in the construction can be allowed in order to permit economical bar placing and do not apply to the fabrication of bars. There is not negative tolerance permitted for the cover.

Post a Comment

Previous Post Next Post